Atosiban Acetate Injection–1
Atosiban Acetate Injection–1 【Drug name】
Generic name：Atosiban Acetate Injection
English name：Atosiban Acetate Injection
Main ingredients：Atosiban acetate
Chemical name：1 – (3 – mercaptan propanol acid) – 2 – (Ο – ethyl – D – tyrosine) – 4 – L – threonine – 8 – L – orn
Accessories：Mannitol, hydrochloric acid, water for injection【Character】
This product is a clear colorless liquid.【Indication】
Atosiban is applicable to pregnant women who:
– regular uterine contractions at least 30 seconds at a time, more than 4 times every 30 minutes
– cervical dilatation 1 ~ 3cm (0 ~ 3cm) and uterine softening/thinning should be greater than 50%
– age 18 or older
– 24 to 33 weeks of gestation
– normal fetal heart rate
Atosiban Acetate Injection–1 Related information
Atosiban Acetate Injection–1 [usage and dosage]
Atosiban must be used by doctors experienced in treating preterm labor.
Tosi o veins give class has three consecutive steps: 7.5 mg/ml of acetic acid, tosi class injection (0.9 ml/bottle) for the first time a single dose push note 6.75 mg, then three hours of continuous infusion tosi class o high dose is dilute acetic acid injection (300 mu g/min), then a low dose give tosi class o is dilute acetic acid injection (100 mu g/min) for 45 hours. Treatment should not exceed 48 hours. In a full course of atosiban treatment, the total dose of atosiban should not exceed 330mg.
Once the diagnosis of preterm labor is made, the first single dose intravenous infusion should be started as soon as possible, and intravenous drip therapy should be conducted after the completion of single dose intravenous infusion. If there is continued uterine contractions during atosiban treatment, other treatments should be considered.
For patients with renal and liver insufficiency, there is no information on dose adjustment.
Atosiban Acetate Injection–1
The following table lists all doses of atosiban used:
Step formulation injection/infusion rate atosiban dose
1 0.9ml single dose intravenous infusion was more than 6.75mg for 1 min
Intravenous drip 24ml/ h 18mg/ h for 2-3 hours
3 subsequent intravenous infusion: 8ml/ h 6mg/ h
If repeated treatment with atosiban is required, single-dose injection with 7.5mg/ml of atosiban injection should also be initiated, followed by intravenous infusion with 7.5mg/ml of atosiban concentration for injection.
Procedures for use and operation
Check the vial for particulate matter and discoloration before administration.
Atosiban Acetate Injection–1
Preparation for the first intravenous injection:
0.9ml of liquid was extracted from the 7.5mg/ml atosiban vial labeled with 0.9ml for injection, and a dose was injected slowly (more than 1 minute) through the vein under the strict monitoring of doctors in the obstetric ward. Atosiban for injection of 7.5mg/ml should be used immediately.
After intravenous administration of 0.9ml atosiban acetate injection, the infusion was prepared with atosiban acetate injection. The diluent could be selected as one of the following:
-0.9% (W/V) sodium chloride injection;
-sodium lactate ringer injection;
-5% (W/V) glucose injection.
10ml solvent was extracted from the infusion bag (or bottle) containing the diluent (100ml/ bag or 100ml/ bottle) and discarded. 10ml atosiban acetate injection was added into the infusion bag (or bottle) and 75mg/100ml atosiban infusion was prepared. The infusion rate of 24ml/h (18mg/h) should first be used for intravenous infusion, and the loading dose should be given for 3 hours (the drug should be given in the hospital obstetrics department, and closely monitored by medical staff). The infusion rate decreased to 8ml/h (6mg/h) after 3 hours of administration.
If one bag (or bottle) of infusion is not enough, another bag (or bottle) of 100ml infusion can be prepared by repeating the above preparation method and continue to use.
If the volume of infusion bag (or bottle) is not 100ml, the amount of atosiban acetate injection should be accurately converted to prepare the same concentration of infusion.
In order to achieve the accuracy of dosage, it is recommended to use an infusion device with adjustable infusion unit calculated as “drop/minute”. With intravenous micropumps, a suitable range of infusion rates can be set within the recommended dose.
Due to the lack of contraindication data, this drug should not be mixed with other drugs. If other drugs need to be given intravenously, they must be given in other parts of the body to ensure the speed of administration.
Once the bottle is opened, the product should be diluted rapidly. Dilute solution should be used within 24 hours after preparation.
Maternal adverse reactions are generally mild. Adverse reactions occurred in 48% of patients in clinical trials. Adverse maternal reactions are as follows:
Very common (> 10%) : nausea
Common (1-10%) :
Central and peripheral nervous system: headache, dizziness
Gastrointestinal system: vomiting
Whole body: hot flashes
Cardiovascular: tachycardia, hypotension
Local: injection site reaction
Metabolism and nutrition: hyperglycemia
Uncommon (0.1 ~ 1%) :
Mental aspect: insomnia
Skin and accessories: itching, rash
Rare (< 0.1%) :
Unexpected cases of uterine bleeding and uterine tonus deficiency have been reported. The incidence in clinical trials was no higher than in the control group.
One case of anaphylaxis thought to be associated with atosiban has been reported.
For newborns, clinical trials did not show any specific adverse effects of atosiban. The incidence of adverse events in infancy is similar to that of placebo and beta receptor agonists within the normal variation range.
【 taboo 】
Atosiban cannot be used if:
– gestational age less than 24 weeks or greater than 33 feet
– premature rupture of membranes greater than 30 weeks of gestation
– intrauterine growth retardation and abnormal fetal heart
– prenatal uterine bleeding requires immediate delivery
– eclampsia and severe preeclampsia require immediate delivery
– fetal death in utero
– suspected intrauterine infection
– placenta previa
– early placental detachment
– any condition in which continued pregnancy is harmful to the mother and fetus
– known to be allergic to active substances or any other excipients
[matters needing attention]
In women with premature rupture of membranes that cannot be excluded, the use of atosiban should weigh the potential risk of delayed delivery against the risk of chorionitis.
There is no experience of using atosiban in patients with hepatic and renal insufficiency (see [usage and dosage] and [pharmacology and toxicology]).
There is a lack of experience with atosiban in patients with placental abnormalities.
The clinical experience of using atosiban in multiple pregnancies or at 24-27 weeks of gestation is limited, and the benefits of atosiban for such patients are uncertain.
Atosiban can be used repeatedly, but the clinical experience of repeated use of atosiban (up to 3 times) is limited (see [usage and dosage]).
In cases of intrauterine growth delay, continuation and resumption of atosiban treatment depends on an assessment of fetal maturity.
Uterine contractions and fetal heart rate should be monitored during treatment with atosiban.
As an oxytocin antagonist, atosiban can theoretically promote uterine relaxation, so postpartum uterine contractions may be poor and postpartum bleeding may occur, so postpartum blood loss should be monitored. However, no adverse postpartum uterine contractions have been observed in clinical trials.
[medication for pregnant and nursing women]
Atosiban should only be used if the pregnancy is diagnosed as premature at 24 to 33 weeks of gestation.
No effect on lactation was observed in clinical trials of atosiban. Small amounts of atosiban can be secreted into milk through plasma.
Preclinical studies have not shown that atosiban is toxic to the fetus. There is no data on fertility and yi development in early embryonic yi.
[medication for children]
This product is not suitable for children.
[drugs for the elderly]
This product is not suitable for old people.
In vitro studies have shown that atosiban is not the substrate of the cytochrome P450 system or the cytochrome P450 enzyme that inhibits drug metabolism, so atosiban does not participate in drug interactions mediated by cytochrome P450.
Clinical studies have shown that there is no drug interaction between atosiban and betamethasone in healthy women. When both atosiban and labetalol were administered at the same time, the peak concentration of blood drug of labetalol decreased by 36% and the peak reaching time increased by 45 minutes, but the bioavailability of labetalol did not change and labetalol did not affect the pharmacokinetics of atosiban.
There have been no studies on the interaction of atosiban with antibiotics ergoalkaloids and antihypertensive drugs other than labetalol.
There are few reports of excess in atosiban. There are no specific signs or symptoms of atosiban overdose. There is no specific treatment for atosiban overdose.
[pharmacology and toxicology]
Atosiban is a synthetic peptide that competitively inhibits oxytocin at the receptor level. The results of animal experiments in rats and guinea pigs showed that the binding of oxytocin receptor could reduce the frequency and tension of uterine contraction and inhibit uterine contraction. It also binds to vasopressin receptors to inhibit the action of vasopressin. No cardiovascular effects have been observed in animal studies.
In preterm labor, the recommended dose of atosiban suppresses uterine contractions and quietens the uterus. Soon after the administration of this product, uterine relaxation occurred, uterine contraction was significantly reduced within 10 minutes, and the uterine quiet state was maintained (no more than 4 contractions/hour, up to 12 hours).
The toxicity test results of rats and dogs intravenous administration of this product for two weeks, the dose is close to 10 times of the human treatment dose, or the toxicity test results of rats and dogs intravenous administration for three months show that this product has no systemic toxicity. No adverse reactions were observed when the subcutaneous injection dose was twice the treatment dose of human body.
Reproductive toxicity studies have shown that drug use in pregnant rats from implantation to late pregnancy has no adverse effects on mothers and offspring. The exposure of the rat fetus was four times the dose given intravenously to the patient. Inhibition of lactation in animals may be due to inhibition of oxytocin.
The results of in vivo and in vitro tests showed that there was no mutagenesis or carcinogenic effect.
Pharmacokinetic data were obtained from clinical studies abroad.
Healthy non-pregnant women get intravenous atosiban (10-300 microns, 12 hours or more), steady-state plasma concentrations increase proportionally to doses. Intravenous atosiban infusion to women with preterm labor changes to 300 microns/min, 6-12 microns/h, to steady-state plasma concentrations (mean 442 + 73ng/ml, 298-533ng /ml) within 1 hour.
The plasma protein binding rate of atosiban in pregnant women was 46% ~ 48%. Atosiban can pass through the placenta. The concentration ratio of atosiban to maternal concentrations was 0.12 at 300 microns/min for healthy full-term pregnant women. It is not clear whether there is a fundamental difference between maternal and fetal free atosiban. Atosiban cannot enter red blood cells. The mean distribution volume of atosiban was 18.3 + / – 6.8L.
After intravenous infusion, the plasma concentration of atosiban decreased rapidly, with an average clearance rate of 41.8 + / -8.2 L/ h. The initial half-life of atosiban is 0.21 + / – 0.01 hours, and the final half-life of atosiban is 1.7 + / – 0.3 hours. The clearance rate and half-life of atosiban were independent of dose.
Two metabolites can be identified in human plasma and urine. In vitro, the main metabolite M1 was as effective as the original compound in inhibiting oxytocin induced uterine contractions. Metabolite Ml can be secreted from milk. At the second hour and the end of intravenous infusion of atosiban, plasma concentrations of the major metabolites, M1(des-(Orn8, gly-nh29)-[Mpr1, d-tyr (Et)2, Thr4] -pair, associated with pair stress, were 1.4 and 2.8, respectively. It is not clear whether Ml accumulates in the tissue. Atosiban is found in very little urine, at a concentration 50 times lower than M1. The amount of atosiban in feces is not known.
Patients with liver or renal insufficiency have no experience with atosiban therapy.
【 storage 】 avoid light, airtight, preserved in 2 ~ 8 ℃.
[packaging] silin bottle. One bottle per box.
[term of validity] 24 months.
[approval number] national drug approval letter H20184094
Company name: chengdu shengnuo biological pharmaceutical co., LTD
Production address: dayi county, chengdu city, sichuan province industrial avenue section
Zip code: 611330
How many companies are there in peptide api manufacturer in china? The peptide api market is very promising, and the world is encouraging the development of peptide business. There is a peptide api list on the website Biofda.com, which contains various specifications of peptide APIs for customers to choose from. Shengnuo Technology is a peptide api manufacturer located in Chengdu, a city in southwest China. Not only peptide APIs, but also carnosine custom suppliers and cosmetic peptide suppliers
There are many peptide apis manufacture in China, but they are all small-scale companies. The China peptide company such as Sinotech is a leading company in China and has a very high position.
As a Chinese peptide company, Sinotech has been working silently, hoping to become a top peptide company in the world. There are many countries producing peptides in the world, such as bulk drug substance in India, gmp custom peptide in uk, and peptide production in usa. So what is polypeptide? What kind of peptide synthesis supplier should you choose? Follow our website: www.biofda.com, here will tell you the answer.